How to repair or replace serpentine belt 2007 Honda Accord 3.0L

1) Pull belt tensioner toward rear of vehicle using a 3/8 wrench with 14mm socket.

2) Release tension on belt

3) Remove belt, don’t forget to make a basic diagram on paper of the belt and accessories so you will know how it goes back together.

4) Remove lower Splash shield to make it easier to install belt or a very long 2ft screwdriver will make it easier to align belt around crankshaft pulley.

5) Install splash shield and start vehicle check for correct install.

Note this repair applies to almost all Honda 6 cylinder 3.0L vehicles.

Tools Required

3/8 ratchet
14mm socket or wrench
long screwdriver 2ft-optional

If you require any assistance we are available to perform repairs from 8am-6pm daily.

Sam Postema and Lansing Professional Fleet Auto Repair has maintained and serviced our vehicle fleet of up to 50 vehicles since 1999. They have been honest and up front with....
-Bob Leyko, Paramount Coffee
Read More Testimonials